urmet domus 1067 User Manual

DS1067-062C 61 LBT20063
5.1.3 How to reset an access code
An access code can be reset to its default value if a user forgets it (see paragraph 5.1.1 Default access code).
Proceed as follows to reset a code to its default value.
1) Enter <Master / Installer / Technical Manager code>, press
and then .
2) Press repeatedly until SETTINGS appears.
3) Press
and then several times until USERS appears.
4) Press
and then several times until DEFAULT CODE appears.
5) Press
.
6) Use and to select the user whose code you want to reset. Press to
confirm.
7) Press to confirm the operation (UTxx is the selected user).
8) Press repeatedly to exit from the menu.
5.1.4 Entering an invalid code or using an invalid key
An attempt to enter an invalid access code 21 consecutive times or use an invalid key 21 consecutive times will interpreted
by the control panel as a sabotage attempt. The control panel will consequently generate a tamper alarm and activate the
programmed alarm outputs and the telephone call dialler.
The incorrect code count will be reset as soon as a correct code or valid key is used.
IMPORTANT! Readers and keypads in the entire system will be blocked for 90 seconds after the tenth attempt to
enter an invalid access code or an invalid key. The message “WAIT please” and the time remaining before the end
of the block will appear on the keypads. No code or key can be entered during this time. The system will allow to
enter codes or keys again at the end of the block. The control panel will interpret other ten consecutive attempts to
enter an invalid code (and will block the system for other 90 seconds) as a sabotage attempt and will generate a
tamper alarm.
5.2 THE MENUS
All system configuration and enabling operations are performed using menus. The operations for accessing and navigating
menus are described below.
5.2.1 How to access menus
The menus can be accessed in two ways:
1. By entering an access code (Master, Installer, User or Technical Manager), then
and finally . The displayed
menu will reflect the privileges of the access code used.
2. Alternatively, press directly. The free access below described above will be opened.
UT01:MASTER
SYSTEM STATUS
UT01:MASTER
SETTINGS
SETTINGS
USERS
USERS
DEFAULT CODE
DEFAULT CODE
UT00: INSTALLER
UTxx:...
ARE YOU SURE?
USERS
DEFAULT CODE
1067/052A
12/01/2014 10:10

urmet domus 1067 Specifications

General

Brand	urmet domus
Model	1067
Category	Antenna
Language	English