What to do if no steam coming out of US Steam Cleaner hose?
If no steam is coming out of the hose, check the following: 1) Ensure the steam release button is in the ON position. 2) Check the low water light; if it's on, refill the unit. 3) Verify the pressure is between 3 and 4.5 bars; if not, wait for the unit to build pressure. 4) Drain the boiler and refill it with ¾ of the fill bottle or 1.5L of water.
Why does my US Steam Cleaner take more than 15 minutes to reach full pressure?
If your unit takes more than 15 minutes to reach full pressure (3.5-4.5 bars), consider these points: 1) Check if the unit is plugged into an extension cord. If it is, ensure the cord is 12 gauge and a maximum length of 25 ft. 2) See if other appliances are plugged into the same electrical outlet. If so, unplug them or use a different circuit. 3) Consider whether the boiler tank has been cleaned recently. Refer to the maintenance and cleaning instructions for guidance.
How to troubleshoot no power to US Steam Cleaner?
If there is no power to the unit, check the circuit breaker or circuit panel for a tripped breaker.
What to do if water coming out of hose while US Steam Cleaner is heating?
If water is coming out of the hose while the steamer is heating, make sure the steam button is in the OFF position.
General| Model | US1900 |
|---|---|
| Type | Steam Cleaner |
| Power | 1500W |
| Runtime | 45 minutes |
| Water Tank Capacity | 1.5L |
| Steam Pressure | 4.5 bar |
| Weight | 4.5 kg |
| Cord Length | 5 m |
| Accessories | Measuring Cup |
To Next Page