QUICK START GUIDE
DO NOT PLUG IN STEAM CLEANER UNTIL INSTRUCTED
1. OPEN SAFETY CAP AND FILL TANK WITH WATER: Press and hold
down while turning the safety cap counter clockwise to open. Remove the cap.
Pour in the water from the filler bottle leaving about 1 inch of water in the bottle to
prevent overflow in the tank.
2. REPLACE THE SAFETY CAP AND TIGHTEN: Turn the cap clockwise to close. Keep
pressing and turning the cap until it is tight.
Note: This cap does not sit flush on the machine and will continue to turn once fully tightened.
3. PLUG IN THE STEAM CLEANER: Plug the power cord into an outlet. The steam cleaner
should be the only appliance plugged into an outlet. Use only a 15AMP extension cord. If you use an
extension cord, the heating will take longer and steam pressure may be less than optimum.
4. CONNECT HOSE TO STEAM CLEANER: Lift the hinged hose socket
cover on the front of the steam cleaner and insert the square end of the hose into
the socket until you hear a click.
5. POWER ON THE STEAM CLEANER: Press the
POWER button to heat the water in the boiler. It will take 9
minutes before your steamer is ready to use. The green
Steam Ready light will illuminate when ready. The Pressure
Gauge must read 3.5 to 4.5 bars before use.
6. PRESS THE STEAM RELEASE BUTTON (to release
the steam from the boiler to the hose). The orange light on
button will illuminate.
7. BLEED THE SYSTEM BEFORE USING: Bleed the hose by turning on low-pressure steam to
release excess water from the hose into a towel for about 10 seconds.
8. SELECT STEAM PRESSURE SETTING.
To Next Page
Loading...