Living & Bed Rooms
Walls, painted trim or molding
Use the large floor brush with a bonnet on the low steam setting with a bonnet. Pretest an
inconspicuous area to be cleaned for paint thickness since it is easy to take paint off walls.
Wallpaper
a. Washable - If surface is heavily soiled, pre-steam surface and spray the towel with
Vapormate®. Follow up with a clean towel to remove soap residue. If wallpaper is textured, pre-
steam 2 inches off surface on low or medium steam settings. Wipe with towel after treating.
Do not stay on one spot too long.
a. Non-Washable - Use large triangle brush with a bonnet. Preheat towel and wipe with no
steam. Move quickly with smooth strokes. Do not stay on one spot too long.
b. Removing - Use wallpaper remover attachment (sold separately) or use the large triangle
brush with bonnet. Start in one corner hold in one spot for 5 to 10 seconds. Pull corner out
start peeling back while moving wallpaper remover or triangle brush slowly back and forth.
Painted walls and ceilings: CAUTION: THE STEAM MAY REMOVE SOME PAINT.
a. Oil Paint - Use large triangle brush on low steam. Do not stay on one spot too long. Use
extension tubes to reach ceilings.
b. Latex Paint - Use large triangle brush with a towel on the low steam setting. Preheat the towel
and wipe with no steam. Do not apply pressure. Move quickly with smooth strokes or use
nozzle about 5-inch off surface to pre-steam spot
Tracks, Moldings
a. Tracks - Use 1-hole nozzle with 1” nylon brush on low or medium steam.
b. Moldings - Use 1-hole nozzle on low or medium steam. Hold the nozzle in one hand and a
towel in the other hand. Move the nozzle and towel at the same time in one direction, blowing
the dirt into the towel. Hold the nozzle parallel to surface. Move quickly. Wipe with dry towel.
Blinds USE ONLY ON METAL BLINDS
Close blinds. Use a low steam setting with the large triangular brush with an attached bonnet. Work
gently in a horizontal direction.
Open blinds and use 1-hole nozzle to blow dust onto window on medium steam.
Upholstery ALWAYS CHECK AREA FOR SCOTCH GUARDING.
Use the large floor or triangle brush with bonnet, heat bonnet 3 to 5 seconds at low steam. Pretest
an inconspicuous area and work quickly and lightly especially if fabric has Scotch Guard. If material
seems to be getting too wet, cut steam off. Reheat towel as needed.
Leather
DO NOT CLEAN INTERIOR LEATHER FURNITURE WITH STEAM.
Vinyl
Using 1-hole nozzle, blow out cracks and crevasses. Use appropriate brush.
Windows
To Next Page
Loading...