EasyManua.ls Logo

US Steam US1900 - Bathroom

US Steam US1900
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Cabinet or Drawer Facings
Use the large triangular brush with a bonnet at low or medium steam.
Corners/Crevices
Use the 1-hole nozzle attached to the hose handle at low or medium steam to blow out dirt. Catch
dirt with a spare cotton towel to prevent it from spraying everywhere.
Refrigerator – Please remove food, bins and shelves from the refrigerator before cleaning.
a. Exterior Surfaces – Use the large triangular brush with a bonnet on low or medium steam.
b. Interior Surfaces – Use the 3-inch round brush or small triangular brush with the 3-hole nozzle
on low or medium steam. Use separate towel to wipe up loosened dirt. Never use hot steam on
cold glass.
c. Door Moldings – Use the 1-inch nylon bristle round brush with the 1-hole nozzle. Use separate
towel to mop up loosened dirt.
d. Defrosting Freezer – Use the 1-inch nylon bristle round brush with the 1-hole nozzle on low or
medium steam. Use separate towel to mop up water.
Dishwasher
Use the 1-hole nozzle on low or medium steam to clean out corners and edges. For light
scrubbing, add the 1-inch round nylon brush.
Bathroom
Mirrors/Glass/Windows
Use the squeegee tool on the LOW steam setting.
CAUTION! ALWAYS PREHEAT GLASS WITH THE SQUEEGEE 2-3 INCHES FROM SURFACE
BEFORE CLEANING! DO NOT CLEAN GLASS WHEN TEMPERATURES ARE BELOW
FREEZING POINT! NEVER CLEAN A GLASS THAT HAS A CRACK!
Toilet - DO NOT PUT THE BRUSH OR HOSE HANDLE UNDER WATER
Exterior cleaning uses the small triangular brush with the 3-hole nozzle on low or medium steam.
Interior cleaning use the 1” nylon round brush with the 1-hole nozzle for cleaning on low or medium
steam. Start from the top of the toilet and work down to the base.
Faucets
Use the 3-inch nylon round brush or small triangular brush with the 3-hole nozzle on low.
Bathtub/Shower
a. Fiberglass – Pre-spray the area with heat activated Vapormate®. For crevices use the 1” nylon
brush with the 1-hole nozzle. Use large triangle brush with bonnet on walls of tubs.
b. Ceramic – Use the large triangular brush with a bonnet on low steam setting to avoid scratching
surface.
c. Shower door – Use the large triangle brush with a bonnet on the low steam setting. Lightly
applying Vapormate® assists in naturally removing mineral deposits or soap scum.
CAUTION: DO NOT USE THE BRUSH IN A CONCENTRATED AREA FOR MORE THAN
TWO OR THREE SECONDS, GLASS COULD BREAK.
d. Silicone Sealant – Use the 1-hole nozzle on low or medium steam, no closer than one-inch, use
back and forth movement blowing out debris.