JSD-80 Instruction Manual
3rd Edition. February, 2006
The projector inputs are connected through
standard 9-pin D-type connectors. (These
connectors are included with the JSD-80).
(An adapter board with setscrew terminals
is available for solderless connections.)
Two RCA connectors facilitate easy con-
nection to standard CD players. A software
fade in/fade out algorithm allows smooth
transition between intermission music and
Two RCA connectors are used to connect
to external two-channel sources such as a
sound card in a computer supplying video
The public address balanced microphone
input is available on a standard 9-pin D-type
The “Mic in +” and “Mic in -” terminals are
for the balanced medium-low impedance
microphone inputs. The shield of the micro-
phone cable should be connected to chassis
ground on pin 5. A 9 V DC power pin allows
easy connection of electret (powered) mi-
The Analog input is an eight-channel un-
balanced analog audio input from a digital
soundtrack player. The 25-pin D connector
is compatible with most decoders. Input
level should be 300 mV for all channels. See
The Digital input is a digital domain input
confi gured for eight channels (Four AES-
EBU pairs with sample rate from 32 to 96
kHz). Requires optional AES-EBU Module
Non/Sync Inputs - Digital
Requires optional Module (DI83). An RCA
jack accepts S/PDIF inputs from CD, DVD,
or computer sound cards. Sample rates
from 32-96 kHz PCM are supported, AC3
bitstreams are also supported.
The DI83 module in this processor, which
decodes Dolby® Digital bitstreams, is not
intended for 35mm fi lm. The DI83 is intended
for alternative content only.
Auxiliary Inputs - Digital
Requires optional Module (DI83). An RCA
jack accepts S/PDIF inputs from CD, DVD,
or computer sound cards. Sample rates
from 32-96 kHz PCM are supported. AC3
bitstreams also are supported.