USTM WS-20-LCD-CLARO - Start-up Instructions; Softener Components

12
EN
Before starting the device, provide a 1/2” flexible hose (a.), salt tablets (b.), hex key (c.), silicone grease (d.).
3. Start-up instructions
a.
b.
sól
pastylkowana
c.
d.
4. Soener components
1. Compact soener
2. By-pass along with a mixer
3. Power supply
4. 1” Connections
5. Fasteners (for connecting the bypass with the head)
6. Users' Manual
1.
4.
2.
3. 5.
5. Soener installation
Before installation please read this manual carefully and comply to all safety precautions related to starting-up
and operation. In case of any questions please contact the dealer or the manufacturer.
Before installation remove all parts out of the box. Check if the device has not been damaged during transport.
All comments should be reported to the seller immediately.
The device should be removed from the box carefully. The soener can be heavy, so when carrying, grab it "from the
bottom". It is forbidden to move the device by grabbing hoses, by-pass and other delicate parts. Avoid moving across
the floor. It is forbidden to drop the device, putting it on sharp or angular edges and turning upside-down, because this
may lead to permanent damage of the soener.
O
UT
I
N
SERWIS
BY P
ASS