Using the Operation Panel
4-80
Security
The security functions can be set up to protect printer operation and the
print data.
The options available in Security are as follows:
• ID (Administrator ID input)
• Password (Administrator Password input)
• I/F Block (Interface (external device) block setting)
• WSD-PRINT (WSD-PRINT setting)
• Enhanced WSD (Enhanced WSD setting)
• EnhancedWSD(SSL) (Enhanced WSD (SSL) setting)
• IPP (IPP setting)
• SSL Server (SSL Server setting)
• IPSec (IPSec setting)
• Thin Print (Thin Print setting)
• LAN Interface (LAN Interface setting)
• Security Level (Security Level setting)
1 Press [MENU].
2 Press or repeatedly until Security > appears.
ID (Administrator ID input)
To use the Security function, you must enter an administrator ID. For
information on how to set the administrator ID, refer to Administrator
(Administrator settings) on page 4-95.
1 Press while Security > is displayed.
2 The message display shows ID and a blinking cursor (_).
3 Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use and to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4 Press [OK]. Proceed to the next step Password (Administrator
Password input).
Password (Administrator Password input)
To set up the Security functions, you must enter an administrator ID and
administrator password. For information on how to set the administrator
password, refer to Administrator (Administrator settings) on page 4-95.
1 Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows
Password
(Administrator password input) and a blinking cursor (_).
Note When Embedded Web Server RX is used, network
parameters and security settings can be conveniently
changed and checked from your PC. For more information,
refer to the Embedded Web Server RX User Guide.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
