A-11
Appendix
Optional Functions
You can use the optional applications installed on this machine.
Overview of the Applications
The applications listed below are installed on this machine.
• UG-33 (ThinPrint)
This application allows print data to be printed directly without a print
driver.
1 Press [MENU].
2 Press or repeatedly until Op functions > appears.
ID (Administrator ID input)
To use the Optional functions, you must enter an administrator ID. For
information on how to set the administrator ID, refer to Administrator
(Administrator settings) on page 4-95.
1 Press while Op functions > is displayed.
2 The message display shows ID and a blinking cursor (_).
3 Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use and to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4 Press [OK]. Proceed to the next step Password (Administrator
Password input).
Password (Administrator Password input)
To set up the Optional functions, you must enter an administrator ID and
administrator password. For information on how to set the administrator
password, refer to Administrator (Administrator settings) on page 4-95.
1 Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows
Password
(Administrator password input) and a blinking cursor (_).
2 Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use and to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
3 Press [OK]. The Op functions screen appears.
Note Restrictions such as the number of times the application
can be used during the trial period differ depending on the
application.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
