Using the Operation Panel 4-69
3 Press or to select whether automatic detection is enabled.
4 Press [OK]. The automatic detection setting is set and the IPv4
Setting menu reappears.
IPv6 Setting (TCP/IP IPv6 settings)
This selects the settings for TCP/IP (IPv6).
TCP/IP (IPv6) is based on the current Internet protocol, TCP/IP (IPv4).
IPv6 is the next-generation Internet protocol and expands the available
address space, which resolves the problem of the lack of addresses
under IPv4, while also introducing other improvements such as additional
security functionality and the capacity to prioritize data transmission.
1 In the TCP/IP Settings menu, press or to select IPv6
Setting.
2 Press [OK]. The IPv6 Setting menu screen appears.
The options available in the TCP/IP (IPv6) settings are as follows:
• TCP/IP(IPv6) (Enable/disable TCP/IP (IPv6))
• RA(Stateless) (RA (Stateless) setting)
• DHCPv6 (DHCPv6 setting)
IMPORTANT The RA (Stateless) and DHCPv6 menu options for TCP/
IP (IPv6) are displayed when TCP/IP (IPv6) is enabled.
TCP/IP(IPv6) (Enable/disable TCP/IP (IPv6))
This specified whether TCP/IP (IPv6) is used.
1 In the IPv6 Setting menu, press or to select TCP/IP(IPv6).
2 Press [OK]. The TCP/IP(IPv6) screen appears.
3 Press or to select whether TCP/IP (IPv6) is enabled.
4 Press [OK]. The TCP/IP (IPv6) setting is set and the IPv6 Setting
menu reappears.
To Next Page
Loading...
Need help?
General
