Mounting the WIU-4 7
Mounting the WIU-4
Figure 1. Mounting instructions
1. To mount the WIU-4 board in the 2 gang electrical
box, remove the electrical box cover and clean it
with the alcohol wipes provided in the mounting
hardware kit.
2. Apply the four standoffs, provided in the mounting
hardware kit, to the four corners of the WIU-4 board,
as shown in
Figure 1.
3. Remove the adhesive liner on the standoffs and
attach the WIU-4 board to the electrical box cover,
making sure the WIU-4 board does not interfere
with or touch the sides of the electrical box.
To Next Page