What to do if UTICA BOILERS Boiler control module detects flame after gas valve is closed?
If the UTICA BOILERS Boiler control module detects a flame more than 10 seconds after the gas valve is closed, the suggested solution is to replace the gas valve.
What to do if UTICA BOILERS Boiler flame is detected before gas valve opens?
If the UTICA BOILERS Boiler detects a flame before the gas valve opens, the suggested solution is to replace the gas valve.
What to do if there is an external voltage supplied to DHW T-T or CH T-T terminals in UTICA BOILERS Boiler?
If there's an external voltage supplied to the DHW T-T or CH T-T terminals in your UTICA BOILERS Boiler, you should eliminate the voltage by using a dry contact relay.
What to do if UTICA BOILERS Boiler Control Module has an internal error?
If the UTICA BOILERS Boiler Control Module has an internal error, the suggested solution is to replace the Control Module.
General| Brand | Utica Boilers |
|---|---|
| Model | UBSSC-299 |
| Category | Boiler |
| Fuel Type | Natural Gas |
| Max. Heating Input (BTU/hr) | 299, 000 |
| Input BTU | 299, 000 BTU/hr |
| Output BTU | 293, 000 BTU/hr |
| Efficiency | 95% |
To Next Page