To Next PageTo Next Page
Need help?Do you have a question about the UTICA BOILERS USC and is the answer not in the manual?
Explanation of hazard alert symbols used in the manual for varying risk levels.
Crucial safety directives for boiler installation, maintenance, and operation.
Conformity requirements for installation codes and standards in the US and Canada.
Guidelines for boiler placement, including required clearances to combustible materials.
Instructions for connecting boiler supply and return piping, including bypass piping.
Illustrations and notes for various piping configurations like mixing valve and primary secondary.
Categorization of gas appliances based on flue gas pressure and temperature.
Critical warnings regarding vent suitability for different appliance categories.
Steps for safely removing a boiler from a common venting system.
Table detailing maximum gas pipe capacity based on pipe size and length.
Important safety instructions for connecting and testing gas lines, prohibiting open flames.
Requirements for electrical wiring, grounding, and disconnect switch installation.
List of component codes and diagrams for USC series boilers.
Instructions on proper placement and installation of thermostats for optimal performance.
Step-by-step guide for lighting the boiler with a hot surface pilot system, including safety.
Instructions for starting and operating the boiler, including thermostat settings.
Procedure for safely turning off the gas supply to the boiler for service or shutdown.
Detailed description of the boiler's operational steps during a call for heat.
Explanation of how the boiler responds to high limit or blocked flue conditions.
Essential checks and cleaning tasks before the start of each heating season.
Procedures for adjusting the pilot flame and inspecting main burners for optimal performance.
Detailed steps for disassembling and cleaning the boiler's flue gas pathways.
Illustrations showing components like jacket, vent pipe adapter, and flue collector.
Instructions for connecting a manometer to check venter static pressure.
Required static pressure values and checks for intake/exhaust pipe obstructions.
Steps to check and adjust gas input rate using the gas meter and manometer.
List of part numbers and descriptions for the pilot assembly.
Diagram and part numbers for various jacket panels of the USC series.
Diagram and part numbers for heat exchanger sections and related components.
Diagram and part numbers for base components, burner tubes, and orifices.
Diagram and part numbers for air intake adapters, deflectors, and covers.
Diagram and part numbers for piping fittings, harnesses, and control components.
Diagram and part numbers for electrical parts like pressure switches and transformers.
Diagram and part numbers for flue collector, vent adapter, and venter assembly.
Diagram and part numbers for the vent termination kit components.
Table of technical data including input/output capacity, dimensions, and AFUE.
List of standard equipment and relevant certifications for the USC series boilers.
General| Brand | UTICA BOILERS |
|---|---|
| Model | USC |
| Category | Boiler |
| Language | English |
