Uwatec MK 25 - Filter and Fitting Reassembly; Filter, O-ring, and Retainer Assembly; DIN Fitting Lubrication and Assembly

SCUBAPRO MK 25/MK 20 First Stages
2003 SCUBAPRO
Important note
: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
10
Monoject
Replace the filter and star retainer.
Lubricate the yoke nut o’ring.
Insert the filter, o’ring, and star retainer
into the yoke nut. Assemble with the
yoke saddle.
Monoject
For DIN Regulators
Lubricate the DIN fitting-to-body o’ring.
Assemble the o’ring and DIN fitting to
the regulator body.
Reassemble and tighten the yoke nut
to the regulator body. Torque to 266
in-lbs/30 N-m.
Place the yoke cover on the yoke.