UWE APM-6 - Installation; Specifications

1. INSTALLATION
Because of metrological legislation, access to some
metrological parameter settings is restricted to
authorized personnel. Do not attempt to change any of
the built-in parameters. Contact your scale dealer for
installation and technical assistance.
CAUTION:
This unit is legal for trade only when it is sealed (and/or
stamped) and bearing a serial number. Do not attempt
to break the seal (or stamp) affixed to this scale or
remove the serial number. Contact your dealer for more
information and after sales service.
For most accurate weighing results, do not use the scale
where or when the environmental conditions fall outside
those listed in SPECIFICATIONS.
Do not attempt to open this unit or conduct any trouble
shooting other than that listed in TROUBLE SHOOTING.
2. SPECIFICATIONS
Model No. Capacity (Max) Division (e)
APM-6 (Non-NTEP) 6kg/15lb 0.002kg/0.005lb
APM-15 (NTEP) 15kg/30lb 0.005kg/0.01lb
APM-30 (NTEP) 30kg/60lb 0.01kg/0.02lb
APM-60 (NTEP) 60kg/150lb 0.02kg/0.05lb
APM-150 (NTEP) 150kg/300lb 0.05kg/0.1lb
Tare Range 1/3 Max. ¡ e
Power-on Zero Range ¡Ó10% Max.
Zero Range ¡Ó2% Max.
Min. Load 20e
Max. measuring range
9.0mV
Min. signal voltage per
verification scale
interval
1.5 V
Power source
BY EXTERNAL POWER ADAPTOR OR
RECHARGEABLE BATTERY
Minimum battery
voltage
5.5 VDC
Load cell Excitation
voltage
5 VDC
Minimal load cell
impedance
85
Maximal load cell
impedance
1000
Load cell connection
4-wire
Operation
Environment
-10
o
~40
o
C (14
o
~104
o
F)
Non-condensed. R.H.¡85%
Specifications subject to change without notice.
NOTE:
NTEP = Approved, legal for trade
Non-NTEP = Not approved, not legal for trade