a. Scale is off
b. Press and hold TARE, then press ON/OFF
c. Scale displays F.1
d. Press TARE four times
e. Scale displays F.9
f. Press MODE to select between ¡Tr_on¡¨ or TroFF¡
-To enable Auto Tare Function, press TARE when Tr_on
appears
-To disable Auto Tare Function, press TARE when TroFF
appears
g. Press TARE for next function setup or ZERO to restart
the scale
NOTE:
The Auto Tare Function will not be accessible if the
unit is purchased as legal for trade.
5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a. Connect the load cell signal and power to the
indicator properly.
b. Place the scale on a level and firm surface.
c. The indicator is turned on.
d. The ZERO INDICATOR is on. If not, press ZERO to set
display to zero.
5.2 WEIGHING
a. Always place an object onto the scale gently.
Excessive force applied to platter may cause damage
to weight sensor.
b. The weight of the object is displayed on the indicator
automatically.
c. It is a good practice to remove all loads from scale
after weighing. It will prolong the lifetime of
weight sensor.
5.3 SELECT WEIGHT UNIT
Press MODE to shift between metric or avoirdupois weight
units. The weight unit used before power off will be
employed when the scale is turned on again.
To Next Page
Loading...
