To Next Page
M
Matthew WhiteAug 1, 2025
What to do if UWE SEK-3000 Scales display shows a symbol?
- MMelissa CarpenterAug 1, 2025
If the UWE Scales displays a symbol, it indicates a low battery warning. Recharge the battery to resolve this issue.
What to do if UWE SEK-3000 Scales display shows a symbol?
If the UWE Scales displays a symbol, it indicates a low battery warning. Recharge the battery to resolve this issue.
Why is the weight not accurate on my UWE SEK-3000?
If your UWE Scales weight is not accurate, first check for any objects stuck on the scale and remove them. Also, external factors like wind or RF interference can cause this. Try using the scale in an environment free of such interference.
How to fix UWE SEK-3000 that cannot be turned on?
If your UWE Scales cannot be turned on, there might be several reasons: * The adaptor might not be plugged in correctly; re-plug it into the scale. * The rechargeable battery may be low; recharge it. * The adaptor voltage may be incompatible with the electrical outlet; replace the adaptor with one that has the correct voltage.
Why do UWE Scales turn off automatically?
The Auto Power Off function might be enabled on your UWE Scales. To change this setting, enter function F4.
What to do if UWE Scales display shows a low battery symbol?
If your UWE Scales display shows a low battery symbol, it means the battery is low. To resolve this, recharge the battery.
Keys for inputting numbers for settings like HI-OK-LO.
Used to input "0" or set weight as OK value. LED for OK lights up.
Used for counting function to input item count and store sample weight.
Tares the weight of the load on the platter, with full tare available.
Turns scale on or sets display to zero. Can control backlight.
Changes weighing units/resolution and HI-OK-LO range.
Recalls accumulated total weight or pieces from memory.
Accumulates weight or pieces into memory.
Sets the LO limit for HI-OK-LO when inputting numbers or placing loads.
Sets the HI limit for HI-OK-LO when inputting numbers or placing loads.
Clears previous settings for HI-OK-LO (high, low, standard, range).
Turns the scale off.
Displays battery charging status (red for charging, green for full).
Lights up when weight/pcs is lower than the set LO value for HI-OK-LO.
Lights up when weight/pcs is within the OK value range for HI-OK-LO.
Lights up when weight/pcs is higher than the set HI value for HI-OK-LO.
An arrow indicating a zero weight status.
An arrow indicating TARE function is in operation and net weight is displayed.
Sign appears when the battery is low.
Arrow indicates the accumulation function is in use.
Arrow indicates accumulation data is currently shown.
Shows the current weighing unit employed.
Set the Auto Zero Tracking range.
Span Value display.
Software version display and full display test.
Displays default weighing units used and disable/enable different weighing units.
Enable/disable Auto Power Off function.
RS-232 Interface Setting (Baud Rate, Parity Setting).
Enable/disable Digital Filter.
RS-232 transmission mode.
Tare mode selection.
Sound Alarm for HI-OK-LO.
Relay Output Mode Selection.
General| Capacity | 3000 g |
|---|---|
| Readability | 0.1 g |
| Calibration | External |
| Display | LCD |
| Weighing Units | g, oz |
| Power | 6 x AA batteries |
