UWE APM-6 - Page 7

employed, or
-By pressing TARE
c. After TARE is pressed, the NET INDICATOR would
disappear
5.8 MEMORY FUNCTION
5.8.1 Accumulate a Transaction To Memory
a. Refer to 5.2 for weighing producers
b. Press M+ to save and accumulate data of current
transaction to memory
c. Indicator displays ¡P. X¡¨ andM+ INDICATOR appears
to indicate that memory contains of stored data
d. Indicator returns to normal display status after 2
seconds
e. Repeat a to c for subsequent transactions
NOTE 1:
¡P. X¡¨ mans the total number of transactions accumulated
to memory
NOTE 2:
-When the operating environment is unstable, scale
memorizes the command and will complete the command when
the environment is stable
NOTE 3:
-Data stored in memory will be cleared when switching
to different weight unit
5.8.2 Memory Recall
Press MR to recall total accumulated weight from memory.
After MR is pressed, indicator displays P. X (X Means
the number of transactions accumulated), then a flashing
value. The flashing value is the total accumulated weight
stored in memory.
When the total accumulated weight is being displayed,
MR INDICATOR appears to indicator that the value being
displayed is the accumulated weight.
Indicator returns to normal display status after 3
seconds.
NOTE:
When scale is not at a zero weight status, MR will not
function. Remove all loads off the platter and try again
5.8.3 Memory Clear
Memory can be erased by:
-Press MR and ZERO simultaneously, or