Need help?Do you have a question about the V-Tec DT-DJ4A and is the answer not in the manual?
General| Brand | V-Tec |
|---|---|
| Model | DT-DJ4A |
| Category | Intercom System |
| Language | English |
Pick up to communicate with visitor.
Connect handset with monitor.
Press to release the door.
In standby mode, pick up handset, then press Call button to activate the inner call; During calling/talking state, press Unlock 2nd button to re-lease the second door.
Send out voice from the visitor.
Door bell call button connection port.
Bus terminal.
Used to Ring Tone setting.
Used to Ring Volume setting.
Used to User Code setting.
Used to Slave Monitor Address or Extended Address setting.
When visitor calls from outdoor station, the monitor rings, pick up handset to talk with the visitor, then press the Unlock button to open the door. If the system connect 2 locks, press Unlock 2nd button to open the second door.
Pick up handset, then press CALL button to activate the inner call, all monitors connected to the system will ring at the same time.
Additional door bell call button can be connected to the Monitor, so that the visitors can ring the door bell again in front of the user's apartment.
In the DT system, every apartment must have a unique identification called User Code. The DIP1 switches are used to configure the User Code for each Monitor.
When multi Monitors are installed in one apartment, these Monitors have to use the same User Code setting, and the Master/Slave mode should be set on the Monitor.
There are four groups ring tones to choose for you:
There are three kinds of ring volume(low-range, mid-range and high-range) to choose for you.
To Next Page
