Vacon 100 X User Manual

Vacon 100 X - Heater(arctic option) vacon • 1
Service support: find your nearest Vacon service center at www.vacon.com
1
1. VACON 100 X - HEATER(ARCTIC OPTION)
Document code: DPD01097B
1.1 Safety
This manual contains clearly marked cautions and warnings which are intended for your per-
sonal safety and to avoid any unintentional damage to the product or connected appliances.
Please read the information included in dangers carefully.
The optional heater allows the drive to operate in low temperature conditions down to -40°C.
This option is intended to be installed inside the drive.
Only Vacon authorized, trained and qualified personnel are allowed to install and maintain
this component.
1.2 Dangers
1.3 Technical data
The optional heater has to be supplied with single-phase 230V. The thermal element is
always supplied and if the drive is connected at -40°C the drive will be heated up until the tem-
perature of -10°C is exceeded. The heating is temperature controlled and an internal fan en-
sures that the air is equally distributed inside the enclosure.
The integrated relay output (switching capacity: 24VDC / 3A, 250VAC / 3A) can be used to con-
trol the power-up of the drive. The contact is closed when the internal temperature is higher
than the minimum allowed value for the power-up (~ -10°C). This can be included and manage
in the logic of the entire system. A bi-color LED (on the enclosure of this option), shows the
status of the drive, ready or not-ready.
The components of the optional heater are live when the element is con-
nected to mains potential. Coming into contact with this voltage is extremely
dangerous and may cause death or severe injury.
The heater can be used only inside the drive and in combination with only the
Vacon 100X. Before connecting the heater to mains, make sure that the Vacon
100X drive is closed firmly.
Table 1. Dangers
Heater connections
Terminal Signal Technical information
L1
Line
Supply voltage input terminals:
1AC 230V 50Hz
500 mA
N
Neutral
X1
Feedback relay output
Switching capacity:
24VDC / 3A
250VAC /3A
Table 2. Technical information on input and relay terminals.

Vacon 100 X Specifications

General

Product Type	AC Drive
Output Voltage	0 - Uin
Enclosure Class/Rating	IP66/Type 4X
Storage Temperature	-40°C to +70°C
Control Method	Scalar control, Vector control
Communication Protocols/Options	CANOpen, DeviceNet
Braking Chopper	Integrated
EMC Filter	Integrated
Operating Temperature	-10°C to +50°C
Relative Humidity	5% to 95% non-condensing
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature, short circuit

Summary

Product Safety and Dangers

General Safety Precautions

Manual contains cautions and warnings for personal safety and to avoid product damage.

Critical Hazards and Electrical Safety

Highlights electrical hazards, risks of severe injury or death from contact with live components.

Technical Data and Specifications

Heater Operation and Temperature Control

Explains heater operation, thermal element, temperature control, and internal fan function.

Input and Relay Terminal Information

Provides details on heater supply voltage terminals and feedback relay output specifications.

Fuse Recommendations

Recommended Fuse Ratings

Lists recommended fuse types and ratings (1A) for the 230VAC heater supply voltage.

Mounting Instructions

Heater Installation Steps

Illustrates the process of mounting the heater option onto the drive unit.