Vacon CX User Manual

Vacon Plc Phone: +358-(0)201 2121 Fax: +358-(0)201 212 205
Service: +358-40-8371 150 E-mail: vacon@vacon.com
Page 22
VV
VV
V
aconacon
aconacon
acon
Multi-purpose Control Application IIMulti-purpose Control Application II
Multi-purpose Control Application IIMulti-purpose Control Application II
Multi-purpose Control Application II
2.22.2
2.22.2
2.2
DIA3 functionDIA3 function
DIA3 functionDIA3 function
DIA3 function
1:1:
1:1:
1: External fault, closing contact =
Fault is shown and motor is stopped when the input is active.
2:2:
2:2:
2: External fault, opening contact =
Fault is shown and motor is stopped when the input is not active.
3:3:
3:3:
3: Run enable
contact open = Motor start disabled
contact closed = Motor start enabled
4:4:
4:4:
4: Acc./Dec contact open = Acceleration/deceleration time 1 selected
time select. contact closed = Acceleration/deceleration time 2 selected
5:5:
5:5:
5: Reverse
contact open = Forward Can be used for reversing if
contact closed = Reverse parameter 2.1 has value 3
6:6:
6:6:
6: Jogg. speed
contact closed = Jogging speed selected for freq. reference
7:7:
7:7:
7: Fault reset
contact closed = Resets all faults
8:8:
8:8:
8: Acc./Dec. operation prohibited
contact closed = Stops acceleration or deceleration until the contact is opened
9:9:
9:9:
9: DC-braking command contact closed =
In Stop mode, the DC-braking operates until the contact is opened,
see figure 6.5. DC-brake current is set with parameter 4.8.
10:10:
10:10:
10: Torque control
contact closed = Forces the motor control mode to torque control, refer to par. 6.1
11
11
1
1:1:
1:1:
1:
Torque reference sign
This selection changes the sign of the torque reference
12: 12:
12: 12:
12: Run enable with coasting
contact open = Run and start disabled (stop always with coasting)
contact closed = Motor run enabled

Vacon CX Specifications

General

Brand	Vacon
Model	CX
Category	Media Converter
Language	English