VV
VV
V
aconacon
aconacon
acon Page 33
Multi-purpose Control Application IIMulti-purpose Control Application II
Multi-purpose Control Application IIMulti-purpose Control Application II
Multi-purpose Control Application II
Vacon Plc Phone: +358-(0)201 2121 Fax: +358-(0)201 212 205
Service: +358-40-8371 150 E-mail: vacon@vacon.com
3.263.26
3.263.26
3.26
Analogue output offsetAnalogue output offset
Analogue output offsetAnalogue output offset
Analogue output offset
3.273.27
3.273.27
3.27
I/O-Expander analogue output offsetI/O-Expander analogue output offset
I/O-Expander analogue output offsetI/O-Expander analogue output offset
I/O-Expander analogue output offset
With these parameters the offsets of the basic control board and I/O-Expander
analogue outputs can be set. See figure 6-17.
Figure 6-17. Analogue output offset
3.283.28
3.283.28
3.28
Digital output DO1 on-delayDigital output DO1 on-delay
Digital output DO1 on-delayDigital output DO1 on-delay
Digital output DO1 on-delay
3.293.29
3.293.29
3.29
Digital output DO1 off-delayDigital output DO1 off-delay
Digital output DO1 off-delayDigital output DO1 off-delay
Digital output DO1 off-delay
3.303.30
3.303.30
3.30
Relay output RO1 on-delayRelay output RO1 on-delay
Relay output RO1 on-delayRelay output RO1 on-delay
Relay output RO1 on-delay
3.313.31
3.313.31
3.31
Relay output RO1 off-delayRelay output RO1 off-delay
Relay output RO1 off-delayRelay output RO1 off-delay
Relay output RO1 off-delay
3.323.32
3.323.32
3.32
Relay output RO2 on-delayRelay output RO2 on-delay
Relay output RO2 on-delayRelay output RO2 on-delay
Relay output RO2 on-delay
3.333.33
3.333.33
3.33
Relay output RO2 off-delayRelay output RO2 off-delay
Relay output RO2 off-delayRelay output RO2 off-delay
Relay output RO2 off-delay
With these parameters it is possible to set on- and off-delays to digital and relay outputs. See
figure 6-18.
ON-delay OFF-delay
Signal programmed to
digital or relay output
DO, RO1 or RO2 output
ud182k_2
Figure 6-18. Digital and relay outputs. On- and off-delays
1.0
0
20 mA
0.5
0 mA
Param. 3. 26
= 25% (+5 mA)
Param. 3. 5
= 100%
Param. 3. 26
= -30%(-6mA)
ao-offse.fh3
Analogue
output
current
Maximum value of
selected signal
To Next Page
Loading...
