Vacon NXP series - Page 144

Table 54: Basic parameters G2.1
Index Parameter Min Max Unit Default Cust ID Description
P2.1.14
Jogging speed
refrerence
0.00 P2.1.2 Hz 5.00 124
See ID413 in Chap-
ter 8 Parameter
descriptions.
P2.1.15 Preset speed 1 0.00 P2.1.2 Hz 10.00 105
Speeds preset by
operator.
P2.1.16 Preset speed 2 0.00 P2.1.2 Hz 15.00 106
Speeds preset by
operator.
P2.1.17 Preset speed 3 0.00 P2.1.2 Hz 20.00 126
Speeds preset by
operator.
P2.1.18 Preset speed 4 0.00 P2.1.2 Hz 25.00 127
Speeds preset by
operator.
P2.1.19 Preset speed 5 0.00 P2.1.2 Hz 30.00 128
Speeds preset by
operator.
P2.1.20 Preset speed 6 0.00 P2.1.2 Hz 40.00 129
Speeds preset by
operator.
P2.1.21 Preset speed 7 0.00 P2.1.2 Hz 50.00 130
Speeds preset by
operator.
* = Parameter value can only be changed after the FC has been stopped.
VACON · 144 MULTI-PURPOSE CONTROL APPLICATION
6
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205