9
6.2 INSTALLATION DIAGRAMS OF THE PEM4 + SPU3 SYSTEM
The PEM4 + SPU3 system, consisting of SPU3 signal processing unit and PEM4 touch screen, can be
connected to the T-Sense
®
or TT-Sense
®
stator control box as shown in below figures.
Figure 2 – Example of PEM4.7 + SPU3 system including T-Sense
®
torque sensor and 2 Touch Screens
Figure 3 – Example of PEM4.8 + SPU3 system including T-Sense
®
torque sensor and 2 Touch Screens
Figure 4 – Example of PEM4.10 + SPU3 system including T-Sense
®
torque sensor and 2 Touch Screens