44
8. MAINTENANCE
No special maintenance is needed for the PEM4 equipment.
The touch screen can be cleaned with a dry and clean cloth.
Do not use any cleaning product or chemical on the screen.
When removing a PEM4 + SPU3 system precautions must be taken to prevent personal
injuries and damage to the touch screen and SPU3.
9. REPAIR
Nothing on the PEM4 + SPU3 system can be repaired on site.
10. TAKE OUT OF SERVICE
Switch off the 24VDC and/or 115/230VAC power supply.
11. REMOVAL AND STORAGE OF EQUIPMENT
Switch off the 24VDC and 115/230VAC power supply.
Make sure that all wires that are connected to the PEM4 + SPU3 system are labelled correctly so that
re-installation of the PEM4 + SPU3 system can be done without any errors.
Disconnect all the input and output wires.
Store the PEM4 + SPU3 system in a box in a cool and dry place, so that the PEM4 + SPU3 system
cannot be damaged.
12. MALFUNCTION AND SEND FOR REPAIR
If the PEM4 + SPU3 system stops working completely contact VAF Instruments for instructions.
In the event the PEM4 + SPU3 system parts has to be sent back for repair, you can send it directly to:
VAF Instruments B.V.
Vierlinghstraat 24
NL-3316 EL Dordrecht
The Netherlands
13. ENVIRONMENT
The PEM4 equipment has no negative influence on the environment during normal operation.
14. DISPOSAL
The PEM4 equipment is made out of metal and electronics. It should be disposed according to local laws
of the country.
To Next Page
Loading...