4. SAFETY INSTRUCTIONS
There are no special safety instructions for the equipment.
5. UNPACKING
Let the equipment acclimatize inside the closed box for at least one hour at the location where the system
will be installed.
When the equipment is taken out of the box, please leave the special protection supplied with the
equipment as long as possible in place to avoid any damage.
The special protection should be stored for the unlikely event the equipment has to be sent for repair.
Dispose of the packing material should be done according to the laws of the country where the equipment
is installed, or according to the rules that are applicable on the vessel.
• Be careful when unpacking the electronic equipment. The content is fragile.
• Do not press on the PEM4 touch screen.
• Be careful not to damage any of the connectors, control modules or wiring.
6. INSTALLATION AND FIRST USE
The PEM4 + SPU3 system will be delivered with the software and correct data settings installed. First
connect all the inputs and outputs to the components. Connect for the PEM4.10 version a grounding
cable to the grounding screw on the backside of the screen, see section 17 drawing 0815-1126.
The power supply wires should be connected at last.
Note: There is an ON/OFF switch on PEM4 touch screen. When the power switch is switched ON the
screen will turn on.
To Next Page
Loading...