24
7.5.2 Settings menu Users
In the Settings menu you can change the settings of the PEM4 + SPU3 system. The Settings menu is
divided into a protected area for adjusting User settings and a protected area for adapting Advanced
settings.
Adapting of Advanced settings should only be done by VAF authorised personnel or in cooperation with
VAF authorised representatives.
Figure 18 – SETTINGS menu
By entering the password (1234) and touching <Log in> the User settings menu is opened.
The settings menu for users is divided in 3 submenus and following data can be set through this settings
menu:
Fuel switch temperatures and automatic/manual switching
between fuels.
When fuel flow meters are connected to the PEM4 + SPU3
system, fuel density, thermal expansion, reference
temperature, Remain on Board (ROB), CO2 conversion factor,
caloric value, water percentage and sulfer percentage of the
fuel can be set.
The amount of cargo, number of persons and the cargo/pax
rate can be set.
7.5.3 Settings menu Advanced
By entering the “Advanced” password and touching <Log in> the Advanced settings menu is opened.
This mode is used to set the customized parameters. These parameters are programmed at the VAF
factory as specified by the customer.
Adapting of Advanced settings should only be done by VAF authorised personnel or in cooperation with
VAF authorised representatives. The “Advanced” password is only granted by VAF personnel and VAF
authorised representatives.
Process control will be interrupted when the PEM4 is in this mode.
WARNING:
WRONG SETTINGS MAY RESULT IN SYSTEM FAILURE. VAF INSTRUMENTS B.V.
WILL NOT TAKE ANY RESPONSIBILITY FOR OPERATIONS CARRIED OUT BY
UNAUTHORIZED PERSONS.
To Next Page
Loading...