Unifuel systems:
When a fuel change-over is done with an Unifuel system, please note that the type of fuel
needs to be changed for both (sets of) engines.
The standard unit for fuel flow output at the PEM4 touch screen is kilogram. It is possible to read out all
fuel consumption measurements in litres instead of kilograms. By selecting the “Consumption in kg/ litres”
key at the right upper corner you can switch over from kg to litre and vice versa.
As a standard the PEM4 + SPU3 system monitors the fuel consumption per engine in
kg/hour. In case you prefer to read out all fuel consumption data in litres/hour you can
change the measurement unit. Please be aware that after switching from kg/hour to
litres/hour and vice versa the value at the accumulated fuel consumption counter is not
correct anymore.
The value at the Total Fuel consumption counter will be correct again after ticking the Reset
key.
Figure 58 – MRV Cargo screen
In the MRV Cargo submenu the amount of cargo, amount of people on board and the cargo/person ratio
can be set.
To Next Page
Loading...