1 Safety
4 Operating instructions ecoTEC plus 0020245033_00
1.3.4 Risk of death due to a blocked or
leaking flue gas pipe
What to do if you smell flue gas in the prop-
erty:
▶ Open all accessible doors and windows
fully to provide ventilation.
▶ Switch off the product.
▶ Inform a competent person.
1.3.5 Risk of death due to explosive and
flammable materials
▶ Do not use or store explosive or flammable
materials (e.g. petrol, paper, paint) in the
installation room of the product.
1.3.6 Risk of death due to changes to the
product or the product environment
▶ Never remove, bridge or block the safety
devices.
▶ Do not tamper with any of the safety
devices.
▶ Do not damage or remove any seals on
components.
▶ Do not make any changes:
– The product itself
– to the gas, air, water and electricity sup-
plies
– to the entire flue gas installation
– to the entire condensate drain system
– to the expansion relief valve
– to the drain pipework
– to constructional conditions that may
affect the operational reliability of the
product
1.3.7 Risk of poisoning caused by
insufficient supply of combustion
air
Conditions: Open-flued operation
▶ Ensure that there is a sufficient supply of
combustion air.
1.3.8 Risk of corrosion damage due to
unsuitable combustion and room air
Sprays, solvents, chlorinated cleaning
agents, paint, adhesives, ammonia com-
pounds, dust or similar substances may lead
to corrosion on the product and in the air/flue
pipe.
▶ Ensure that the supply of combustion air is
always free of fluorine, chlorine, sulphur,
dust, etc.
▶ Ensure that no chemical substances are
stored at the installation site.
1.3.9 Risk of material damage caused by
frost
▶ Ensure that the heating installation always
remains in operation during freezing con-
ditions and that all rooms are sufficiently
heated.
▶ If you cannot ensure the operation, have a
competent person drain the heating install-
ation.
1.3.10 Risk of injury and material damage
due to maintenance and repairs
carried out incorrectly or not
carried out at all
▶ Never attempt to carry out maintenance
work or repairs on your product yourself.
▶ Faults and damage should be immediately
rectified by a competent person.
▶ Adhere to the maintenance intervals spe-
cified.
To Next Page
Loading...
Need help?
General