Operation 4
0020245033_00 ecoTEC plus Operating instructions 7
3.5 Serial number
The serial number is located on a plastic plate behind the
front flap.
3.6 CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
3.7 Energy Saving Trust Endorsed Products
Only the most energy efficient products can carry the
‘Energy Saving Trust Endorsed Product’ brandmark making
it easy for consumers to choose products that have met strict
energy performance criteria.
Available for: Boilers, Heating controls and chemical inhib-
itors, the Energy Saving Trust endorsed product brandmark
gives consumers confidence that a product will cost less to
run, help lower energy bills and reduce carbon emissions.
About the Energy Saving Trust
Energy Saving Trust is an independent and impartial organ-
isation that provides trusted energy saving advice to em-
power millions of people to lead affordable, low energy life-
styles. For more information visit energysavingtrust.org.uk
3.8 Hot Water Association
Vaillant is a full member of the Hot Water Association and
promotes the scheme in association with its cylinder range.
Details are available on the web site www.vaillant.co.uk
3.9 Benchmark
Vaillant is a licensed member of the Benchmark Scheme
which aims to improve the standards of installation and com-
missioning of domestic heating and hot water systems in the
UK and to encourage regular servicing to optimise safety, ef-
ficiency and performance.
Benchmark is managed and promoted by the Heating
and Hotwater Industry Council. For more information visit
www.benchmark.org.uk.
▶ Please ensure that the installer has fully completed the
Benchmark Checklist on the inside back pages of the
installation instructions supplied with the product and
that you have signed it to say that you have received a
full and clear explanation of its operation. The installer is
legally required to complete a commissioning checklist
as a means of complying with the appropriate Building
Regulations (England and Wales).
All installations must be notified to Local Area Building Con-
trol either directly or through a Competent Persons Scheme.
A Building Regulations Compliance Certificate will then be
issued to the customer who should, on receipt, write the No-
tification Number on the Benchmark Checklist.
This product should be serviced regularly to optimise its
safety, efficiency and performance. The service engineer
should complete the relevant Service Record on the Bench-
mark Checklist after each service.
The Benchmark Checklist will be required in the event of any
warranty.
4 Operation
4.1 Operating concept
Operator
control
element
Function
– Setting the hot water temperature
– Cancelling the activation of an operating
mode
– Cancelling a change to a set value
– Going one selection level higher
– Setting the heating flow temperature
– Reading the system pressure
– Activating the comfort mode
– Activating the operating mode
– Confirm setting
– Going one selection level lower
+ at
the same
time
– Calling up the menu
or
– Reducing or increasing the set value
– Scrolling through menu entries
The current function of the and buttons is shown on
the display.
Adjustable values are always displayed as flashing.
You must always confirm a change to a value. Only then
is the new setting saved. You can press to cancel an
operation at any time.
To Next Page
Loading...
Need help?
General
