Functions and operation
Operating instructions for the electronicVED exclusive electric instantaneous water heater 0020176440_00 9
3
> Press the button to quit the Memory function. If you
previously changed the temperature without pressing
the
save button, this change will not be remembered.
3.2.4 Configuring the eco function
The eco function is a function that saves water and energy.
If the
eco function is activated, the water flow is limited by
your VED to 8 litres per minute. Typical water consumption
is around 10 litres per minute.
> Press the
eco button to activate the function.
> Press the
eco button again to deactivate the function.
max. 42 °C eco
38.0 °C
-+
MEMO eco
If the eco function is activated, it will be shown on the top-
right of the display.
3.2.5 Activating/deactivating the key lock
> Press and hold both the + and — buttons at the same
time for longer than 3 seconds.
> Press and hold both the + and — buttons at the same
time for longer than 3 seconds again to deactivate the
key lock.
i
When the key lock is activated, pressing any dis-
play button will not have any effect; all functions
are locked.
3.2.6 Call up the menu and return to the
temperature display
> Briefly press the Memo and eco buttons simultaneously
to access the menu.
> Briefly press the button to return to the temperature
display.
Menu
Display settings
Scald protection
Consumption
Select language
ok
All the basic VED settings will be carried out from this
menu.
i
Use the button to go back through the menus
one step at a time.
> Continuously press the button until the initial display
screen is shown again.
max. 42 °C
42.0 °C
-+
MEMO eco
To Next Page
Loading...
