31
2
Scroll through and select the system
diagram number applicable to the system
installed. Refer to page 32 for relevant
system configuration settings in
accordance to the schematic drawing of
the system installed.
3
If applicable, select the configuration
number. Refer to page 32 for relevant
system configuration settings in
accordance to the schematic drawing of
the system installed.
4
Press ‘OK’ to finish the installation
assistant. This will then take you into the
System Configuration menu. Refer to page
32 for relevant system configuration
settings in accordance to the schematic
drawing of the system installed.
Navigating To the System Configuration Menu
Use the selection buttons (found just below the screen) for going backwards, forwards
and confirming selections. Use the rotary knob for scrolling through menus and for
making adjustments within selected settings.
1
Press the menu button.
2
Scroll down and select ‘Installer level’.
To Next Page
Loading...
Need help?
General