32
3
The default code is ‘000’.
4
Select ‘System configuration’.
For the relevant settings in the VRC700 controller, refer to page 32. Care must be
taken going through each setting diligently and adjust as necessary in accordance to
system configuration and property requirements. Only key settings are listed in this
document, refer to the VRC700 installation manual for further guidance.
VRC700 System Configuration Relevant Settings
• Settings with asterisk (*) are recommendations and not necessarily vital to
system operation.
• Settings with N/A (Not Applicable) may still be displayed in the controller but
can be ignored.
• Not all settings are displayed, commissioning of the controller should be done
diligently; going through each adjustable option with consideration to the
property and system configuration.
• Drawing specific settings are arranged in order of drawing number.
To Next Page
Loading...
Need help?
General