setting defines how long the device can
remain inactive before powering off automatically. The
time limit options are 10, 30, and 60 minutes. Select
to disable automatic power off.
HM40 has no permanent memory for graph data:
when the meter is turned off, the graphs are
cleared. Only tagged points are stored in
permanent memory. To avoid losing graph data
while working, set a suitable delay for the
automatic power off or disable it.
Navigation
Navigation setting affects the behavior of arrow buttons
in the measurement view:
-
: Up arrow moves parameter selector left,
down arrow moves it right
-
: Reverses the direction
Rounding
Rounding setting affects the number of decimal places
that are used to show the measurements:
-
: Measured values are rounded to
: Measured values are shown with
To Next Page
Loading...
Need help?
General
