Attaching Probes to Indigo Transmitters
Figure 13 Attaching the Probe to Indigo 200 Series
1. Insert the probe or the connection cable into the transmitter's connector. Use of
connection cable is recommended for strain relief.
2. Turn the locking wheel of the transmitter to lock the probe or cable in place.
Do not turn the probe or the cable itself, as that will damage the connectors.
3. If you are using a connection cable, connect the probe to the cable.
4. When the transmitter recognizes the connected probe, it shows a notification message on
the display.
18 M211982EN-D
To Next Page
Loading...
