Valeo TM08 User Manual

• M

  Mark WaltonAug 13, 2025

  What to do if my Valeo Air Compressor is not running?

  

  Same questionReply

  • F

    flemingwilliamAug 13, 2025

    If the Valeo Air Compressor is not running and no cool air is blowing out, it could be due to several reasons. The compressor's internal parts might be damaged, requiring a replacement. There could be a refrigerant shortage, which means you'll need to fix the refrigerant leakage and refill it to the correct amount. A lead wire might be short-circuited, or the wiring connector might not be properly seated, in which case you should replace the lead wire if it's defective. The magnetic clutch could be damaged, suggesting a repair or replacement. Lastly, the magnetic clutch air gap might be too wide, needing adjustment or replacement of the magnetic clutch.

    

    Reply
• T

  Tyler HessAug 16, 2025

  What to do if Valeo TM08 is running but no cool air is coming out?

  

  Same questionReply

  • P

    pecklaceyAug 17, 2025

    If your Valeo Air Compressor is running but not blowing cool air, it could be due to several reasons. There may be poor compression, indicating the compressor needs replacement. A refrigerant shortage could be the cause, requiring you to fix the leak and refill the refrigerant to the correct level. Slipping on the magnetic clutch friction surface can also be a factor; check the battery voltage or replace the magnetic clutch. A loose connection in the magnetic clutch electrical circuit might be the issue, suggesting you replace the magnetic clutch after confirming it's defective. Additionally, the magnetic clutch belt could be slipping, needing belt tension readjustment. Finally, a defective thermostatic switch could be the culprit, so replace it after confirming it's defective.

    

    Reply
• N

  nicholas68Aug 20, 2025

  Why is my Valeo TM08 smoking?

  

  Same questionReply

  • A

    Alyssa MooreAug 20, 2025

    If your Valeo Air Compressor is emitting smoke, it could be due to refrigerant leaking from uncoupled or burst piping, requiring you to fix the leak and refill to the correct amount. Alternatively, it could be caused by refrigerant blowing from the high-pressure relief valve due to excess refrigerant, in which case you should reduce the refrigerant charge to the correct amount.

    

    Reply
• W

  Wesley SimsAug 25, 2025

  What to do if Valeo TM08 Air Compressor runs intermittently?

  

  Same questionReply

  • R

    rreedAug 25, 2025

    If the Valeo Air Compressor runs intermittently, with cool air coming out only sometimes, it could be due to several reasons. An excess of refrigerant might be the cause, requiring you to reduce the refrigerant charge to the correct amount. The condenser fan might have failed, suggesting you replace the condenser after confirming it is defective. A loose connection in the magnetic clutch electrical circuit could be the issue, so replace the magnetic clutch after making sure it is defective. Finally, a defective thermostatic switch might be the cause, meaning you should replace the thermostatic switch after confirming it's defective.

    

    Reply
• S

  Sarah JonesAug 28, 2025

  Why is there abnormal noise from the magnetic clutch of my Valeo Air Compressor?

  

  Same questionReply

  • C

    Charles PettyAug 28, 2025

    If you notice abnormal noise from the magnetic clutch of your Valeo Air Compressor, it could be due to magnetic clutch damage, requiring replacement of the magnetic clutch. The air gap might be too wide, so adjust the air gap or replace the magnetic clutch. Alternatively, the magnetic clutch friction surface may be slippery; in this case, check the battery voltage or replace the magnetic clutch.

    

    Reply
• M

  Mrs. Emily Baird MDSep 1, 2025

  How to fix abnormal noise from Valeo TM08 Air Compressor?

  

  Same questionReply

  • A

    andreawyattSep 1, 2025

    If your Valeo Air Compressor is producing abnormal noise, it could be due to a loose compressor installation bolt, so increase the tightening torque of the loose bolts. Another cause could be a wide gap at the attaching portion between the compressor and the bracket, which means you should improve the compressor attaching portion. Lastly, the noise might be due to compressor body internal component damage, indicating the need to replace the compressor.

    

    Reply
• S

  Sharon LaraSep 5, 2025

  How to stop magnetic clutch belt slipping on Valeo TM08?

  

  Same questionReply

  • J

    jacob20Sep 5, 2025

    If the magnetic clutch belt on your Valeo Air Compressor is slipping, ensure the belt alignment is correct by adjusting the compressor installation position. Also, if the magnetic clutch belt is greasy, clean or replace the belt. Finally, if the magnetic clutch belt tension is loose, adjust the belt tension.

    

    Reply
• A

  anthony70Sep 8, 2025

  What causes magnetic clutch friction surface slipping in Valeo TM08 Air Compressor?

  

  Same questionReply

  • M

    Mr. Jon SchneiderSep 8, 2025

    If the magnetic clutch friction surface is slipping on your Valeo Air Compressor, it could be due to a few reasons. The magnetic clutch air gap might be too wide, in which case you should adjust the air gap or replace the magnetic clutch. It's also possible that there's low magnetic clutch voltage, so check the battery voltage. Lastly, the magnetic clutch friction surface might be greasy; clean the friction surface or replace the magnetic clutch.

    

    Reply

Valeo TM08 Specifications

General

Brand	Valeo
Model	TM08
Category	Air Compressor
Language	English

Related product manuals

Valeo TM55

51 pages