Valeport miniIPS2 - Information #Codes

Setting Up the mniIPS2
© 2020 – Valeport Ltd
Page | 18
5.10 Information #Codes
The following commands will cause the sensor to report back various pieces of information, as described:
# Code
Description
#004
Read the sampling rate
#006
Read the address mode status
#008
Read Tare activation status
#010
Read Tare value
#012
Read operating mode
#014
Read data string output format
#015
Read the last measured observation
#019
Read calibrated units
#021
Read unit status
#023
Read user calibration coefficients
#030
Read number of samples for burst averaging
#032
Read firmware version number
#034
Read instrument serial number
#038
Read User calibration activation status
#045
Reads the Pressure Module serial number
#093
Read PCB serial number
#136
Read the set Latitude
#138
Read Pressure module calibration date
#200
Read Pressure sensor serial number
#202
Read maximum transducer pressure range
#210
Read startup message status - on/off
#701
Reads Modbus activation status
#703
Reads Modbus address