26 © 2000 Directed Electronics, Inc.
The learn routine will be exited if:
■ The ignition is turned on.
■ The Program switch is pressed too many times.
■ More than 25 seconds elapses between programming steps.
features menu
The factory default settings are indicated below in bold.
feature descriptions
1 ENGINE CHECK ON/OFF: In the default setting the remote start will monitor either the vehicle's tach wire or
voltage depending on the programming of Feature 2. If programmed off, the vehicle will crank for the pro-
grammed crank time (Feature 5) and will not verify with tach or voltage that the vehicle is running. In the off
setting, if the vehicle fails to start, the ignition can stay on for the entire run duration. Using tach or voltage
check is always recommended if possible.
FEATURE
NUMBER DEFAULT - LED ON SETTING LED OFF SETTING
1 Engine checking on Engine checking off
2 Tachometer checking type Voltage checking type
3 12 minutes (1)* run time 24 minutes (2)*, 60 minutes (3) run time
4 Flashing parking light output Constant parking light output
5 Cranking time 0.6 sec. (1) Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.
6 High voltage check level Low voltage check level
7 Auxiliary output - factory alarm disarm Auxiliary output - special accessory
8 Normal status output Factory re-arm output
9 Activation pulses - 1 (1) Activation pulses - 2 (2), 3 (3)
*NOTE: The numbers in parentheses indicate the number of times the LED will flash.
To Next Page
Loading...