Valet 710T - oem style configuration; two vehicle operation with single transmitter

19 © 1999 Directed Electronics, Inc. Vista, CA
two vehicle operation with single transmitter
You can get two-vehicle operation with the transmitters that come with the system; however, you will not be
able to use all the auxiliary channels of the system (or all the auxiliary channels of the other system), unless
using a 485T 4-button transmitter.
Here's what to do:
1. Using Learn Routine, program Button I into System One as the arm/disarm button. Do this with all four
remotes.
2. Do the same with System Two, except program Button II of all four remotes as the arm/disarm button.
If using DEI
®
485T four-button remotes, all auxiliary channels are available on both vehicles. Before program-
ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.
For example, if you wanted the top two buttons to control Vehicle One and the bottom two buttons to control
Vehicle Two, here is how each system would be programmed:
VEHICLE 2
Button III Lock/Arm, Unlock/Disarm, Panic
Button IV Channel 2
Buttons III and IV Channel 3
VEHICLE 1
Button I Lock/Arm, Unlock/Disarm, Panic
Button II Channel 2
Buttons I and II Channel 3
Button I ......................operates ....................Lock/Arm, Panic
Button II.....................operates ....................Unlock/Disarm, Channel 2
Buttons I and II ...........operate .....................Channel 3
oem style configuration