EasyManuals Logo

Valet System One Installation Instructions

Valet System One
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
WHERE TO RUN CABLE
Cables can be run either:
In the roof space
In false ceilings/bulkhead area
Through and/or around external walls
Under floors (subject to access being available)
Note: Intercom cables should be run as far away from AC wiring as
practicality permits.
Avoid running intercom cable in parallel to AC or any other type of
wiring. (Running across at right angles is OK where necessary)
All aerial wires should be taken to the highest and most accessible
point in the roof.
Allow additional cable at each station for the purpose of termination.
(At least 3 feet )
In the case of cavity brick walls, ensure the wires are pulled through
one of the holes at the rear of the wall box.

Other manuals for Valet System One

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valet System One and is the answer not in the manual?

Valet System One Specifications

General IconGeneral
BrandValet
ModelSystem One
CategoryIntercom System
LanguageEnglish

Related product manuals