Getting Started
5
Screen Introduction
GP-200LT includes 256 patches, with the first 100 (01-A~25-D) containing default factory parameters. When performing
a factory reset, you can separately reset these 100 patches to the default values.
Tap footswitch , , to choose a patch you like. Tap footswitches and together to enter BANK selection menu.
Select a patch
EXP 1: EXP 2: PatchVOL
PatchVOLMixGain
1
BPM: 120
Main Display Screen is the home page displayed right after the power is turned on. You can directly see the key
information and settings of the current patch.
A
J
B
C
D
E
F
H
I
G
A
B
C
D
E
F
G
H
I
J
Main Display Screen
.Patch number
. Patch name
. Patch volume monitor
. Patch BPM
. Patch volume
. EXP pedal state
. Patch state
. DRUM state
. Current footswitch setting
. Quick adjust paras
TUNER
In tuner mode, the LED screen will display the tuning
interface. When you pluck a string, the note will appear in
the center. Left of center is flat, and right of center is sharp.
As you tune your instrument towards the middle, the color
of the scale will change from red (out of tune) to yellow
(near pitch) to green (in tune).
Hold the [CTRL] footswitch to activate the tuner mode.
Ÿ Turn Quick Access Knob 1 to select the work mode of the tuner:
◦ Thru: Your tune will be normal.
◦ Bypass: Eect chain will be bypassed, and you will only hear the dry guitar input sound.
◦ Mute: There will be no output.
Ÿ Turn Quick Access Knob 3 to change the standard A’s frequency ranged from 432Hz to 447Hz, with default set to
440Hz.
Ÿ Tap any footswitch to return back to the Main Display Screen.
To Next Page
Loading...