Valeton GP-200LT - MIDI Device Control; Expression Pedal Usage

EXP 1: EXP 2: PatchVOL
PatchVOLMixGain
1
BPM: 120
Screen Introduction
7
In a default footswitch setting, you can enter the MIDI control interface by pressing the footswitch 3+4
simultaneously.
This interface can control the external MIDI devices and adjust the settings of the plugins when using the MIDI
learn function in the DAW.
All 4 MIDI switches and 1 MIDI pedal are ready to use in this interface.
MIDI Device Control Functions (MIDI)
CH1
Off
CMD1
CC 0
DATA1
0
DATA 1:O CC0 0
DATA 2:O CC0 0
DATA 3:O CC0 0
FS1
BACK
Each footswitch can have three groups of MIDI information.
CH 1/2/3: default is o, adjustable from 1-16
CMD 1/2/3: range from CC0~CC127~PC. (CC: Control Change)/(PC: Program Change)
DATA 1/2/3: adjust the parameter of CC/PC in CMD 1/2/3
GP-200LT supports two types of MIDI messages (CC/PC), the parameters in DATA 1/2/3 will vary based on the
type of MIDI function you intend to use.
The display of all three groups of MIDI information of
your current footswitch/pedal.
The corresponding parameters of your current MIDI
setting group.
The icon will light blue when the corresponding the
footswitch/pedal is pressed.
Note:
Only in this interface for using GP-200LT to control external MIDI devices.
EXPPedal
The icon will show up on the Main Display Screen at the top left to indicate the expression pedals’ working status:
EXP 1: EXP 2:
The GP-200LT supports the use of two external expression
pedals at the same time. You can use the external expression
pedal to control various parameters in real time.
It is recommended to calibrate the pedal(s) when you use an
external pedal for the first time or change the brand/model of the
expression pedal. Please refer to "Global Settings - EXP
Calibrate".
When connect an expression pedal with EXP 1, it can provide two states of A/B. You can use the built-in footswitches or
external footswitch 3/4 to set the function to set the function of switching the A/B state of EXP 1. For details, please
refer to "GLOBAL SETTINGS - Footswitch" or " GLOBAL SETTINGS - EXP/Footswitch".
Some GP-200LT patches have already been set up to use the EXP 1, without any further set up;
Refer to the expression pedal setting section to customize the expression pedal settings.