Figure 2. PTO 540/1000 r/min+ground speed PTO
(optional)
817
Model Code Page
46. Power take ---off
15. 5. 1993
6000--8750 460 5
8. 11. 1990
2
Z25
Z17
(Z31)
Z25
Z52
Z59
1
On this PTO unit, nominal speeds 540 and 1000 r/min are ob-
tained in thesame way as on a PTO unitwithoutgroundspeed
PTO(seefigure1)
In the figure above shaft (1) is for ground speed PTO. Its front
end has been connected with a coupling sleeve to the rear
end of the ground speed PTO output shaft in the gearbox.
There is a sliding coupler for the ground speed PTO at the
front end of the gearbox bevel pinion shaft.
The ground speed PTO is engaged with the same control
lever as the engine PTO speeds 540 and 1000 r/min.
When the ground speed PTO has been engaged, the PTO
shaft rotates proportional to the rear wheel rotation speed and
poweris transmitt ed from gear (1) to gear (2)onthePTO shaft.
Note! In the picture above the locking flange at the front end
of the PTO shaft is the earlier version. Later version is illus-
trated on page 460/7. Additionally, the clutch housing has
been reinforced with a metal ring, see page 460/9.
To Next Page
Loading...
