Vanderbilt ACT365-ACU - Default Chapter; Table of Contents

Table of Contents
1 Overview 4
1.1 Technical specification 4
1.1.1 Electrical specification 4
1.1.2 Relay load 5
1.2 Ordering details 5
1.3 Monitoring 6
2 Installation 7
2.1 ACT365-ACU 7
2.1.1 Mounting 7
2.1.2 Power supply 7
2.2 ACT365-ACU2A 7
2.2.1 Mounting 8
2.2.2 Mains power up 8
2.2.3 Load Output 8
2.2.4 Standby Battery 8
2.2.5 Tamper 9
2.3 ACT365-ACUPoE 9
2.3.1 Mounting 9
2.3.2 Power Up 9
2.3.3 Troubleshooting 10
2.3.4 Tamper 10
3 Wiring 11
3.1 Typical wiring of ACT365-ACU 11
3.1.1 Wiring exit readers 12
3.2 Fire override configuration 12
3.3 Interlock/airlock configuration 12
3.4 Intruder panel wiring 13
4 Defaulting the Controller and IP Address Configuration 15
4.1 Factory default the Controller (DIP switch 2) 15
4.2 DHCP/static IP addressing (DIP switch 1) 15
4.3 Defaulting the static IP address 16
4.4 Changing static IP address on the ACT365-ACU 16
5 Door Controller Status Indicators 17
5.1 ACT365-ACU 17
5.2 ACT365-ACU2A and ACT365-ACUPoE 17
© Vanderbilt 2019 3 A-100521-c
15.03.2019