Need help?Do you have a question about the Vanderbilt ACTpro-100 and is the answer not in the manual?
General| Model | ACTpro-100 |
|---|---|
| Number of Doors Supported | 1 |
| Reader Ports | 2 |
| Inputs | 4 |
| Outputs | 4 |
| Events | 50, 000 |
| Door Monitoring | Yes |
| Anti-Passback | Yes |
| Certifications | CE, FCC |
| Type | Controller |
| Communication | TCP/IP |
| Power Supply | 12-24V DC |
| Input Voltage | 12-24V DC |
| Operating Temperature | -10°C to 50°C |
Lists different ACTpro controllers and their product codes and descriptions.
Details technical specifications like voltage range, current, dimensions, and temperature.
Specifies the current ratings for the main and auxiliary relays.
Instructions for physically mounting the ACTpro Controller on a wall.
Details how to connect the external DC power supply to the controller.
Provides a general overview of wiring connections for the controller.
Details how to wire Clock&Data readers for entry and exit.
Explains the wiring process for Wiegand readers for entry and exit.
Guides on connecting OSDP readers to the controller, including EOL jumper settings.
Describes various methods for connecting the controller to networks (Ethernet, RS485).
Explains how to wire a push-to-exit button to the controller.
Details connecting a door contact sensor to the controller.
Describes wiring for break glass monitoring, not power removal from the lock.
Explains how to configure fire alarm override for doors.
Details how to configure interlock functionality for doors to allow only one open.
Covers wiring the controller to an intruder alarm panel for arming/disarming.
Details the process to reset the controller to factory default settings using DIP switch 2.
Explains how to configure the controller for DHCP or static IP addressing using DIP switch 1.
Describes how to reset the static IP address to its default value using DIP switches.
Provides instructions on how to change the static IP address via web interface or ACT software.
Lists requirements for configuring deadbolt locks, including firmware and controller capabilities.
Shows wiring diagrams for connecting ASSA ABLOY deadbolt locks to the controller.
Explains operational aspects and fire event behavior for deadbolt locks.
Explains the meaning of the Power, Communications, and Fault status LEDs on the controller.
Addresses issues where a card has not been assigned on the system.
Provides guidance on resolving 'Access Denied' errors, checking user status and rights.
Offers steps to troubleshoot connectivity issues with the ACTpro-1500 controller.
To Next Page
