ASSA ABLOY Hi-O deadbolt lock wiring to ACTpro-1500
A Monitor deadbolt position D Door strike (controls latch)
B Door contact (optional) E Connect Hi-O lock to terminals 5, 6, 7 and 8
C Trigger the deadbolt
l The ACT controller/door station should already be installed and configured in ACT Install.
5.1.2 Operation notes
l In the event of a fire, both the main relay and the aux relay fire until the fire condition is cleared. If
the system is wired as recommended, both the deadbolt and the door strike are energised while
the fire condition is active, allowing free access through the door.
ACTpro-1500 Door Controller – Installation and Operating Instructions Configuring a lock with a deadbolt
© Vanderbilt 2020 22 A-100667
18.06.2020
To Next Page
Loading...
