Vanderbilt ACTpro-100 - 3.6 Push Button (PB) Wiring; 3.7 Door Contact Wiring

From To Network Type Cable Type
LAN ACTpro controller TCP/IP CAT 5/6
ACTpro controller ACTpro readers ACT protocol 8 Core screen (Example Belden 9504 (24 AWG) or
equivalent)
ACTpro-1500 ACTpro controllers TCP/IP Cat 5/6
ACTpro-1500 ACTpro controllers RS485 Belden 9501 (24 AWG)
3.6 Wiring Push Button (PB)
Push button is connected between PB input and 0V. When push button is pressed the main relay is
activated for the configured time.
Push button is also referred to as exit button, egress button, request to exit.
3.7 Wiring Door Contact
Connect door contact between DC input and 0V.
ACTpro-1500 Door Controller – Installation and Operating Instructions Wiring
© Vanderbilt 2020 13 A-100667
18.06.2020