Example 2
The EOL Resistor/Jumper must be ON for the devices at the ends of the bus.
Example 1: EOL ON in the Controller and the fourth Reader. OFF in all other readers.
Example 2: EOL ON in Reader one and four, and EOL OFF in the controller and reader two and
three.
3.5 Wiring controller
Each ACTpro controller can be connected directly to the customer network.
3.5.0.1 Connecting single doors over Ethernet
Connect each controller directly on the customer's LAN.
Each controller must be configured with a unique IP address.
3.5.0.2 Connecting over an IP switch
Connect a controller directly on the Customers LAN and network the remaining controller via the
onboard Ethernet switch (maximum 4 controllers).
ACTpro-1500 Door Controller – Installation and Operating Instructions Wiring
© Vanderbilt 2020 11 A-100667
18.06.2020
To Next Page
Loading...
