Vantrue N1 PRO User Manual

System Setup
After installing the memory card, by default, the camera immediately
starts loop recording video when it connects to a power source and
turn on. If it doesn’t connect to a power source, when you press the
OK button to turn it on, it will not auto start recording, you should press
the OK button to start recording.
While recording, the LED indicator is blinking blue, and a red dot will
flash on the top left of the screen. You can stop/start the recording
by pressing the OK button.
4.4 Loop recording
- 13 -
or Down button to select date and time value, press OK to confirm
and go to next. When the setup is finished, press Power button
to exit.

Vantrue N1 PRO Specifications

General

Resolution	1920x1080P
G-Sensor	Yes
Loop Recording	Yes
Parking Mode	Yes
Frame Rate	30fps
Aperture	F1.8
Night Vision	Yes
Screen Size	1.5 inches
Storage	Supports up to 256GB microSD card
Operating Temperature	-4°F - 158°F (-20°C - 70°C)
Lens	6-Layer Optical Glass Lens
Viewing Angle	160°
GPS	Yes (external GPS module)