TROUBLESHOOTING AND MAINTENANCE
A
02.9685.0001 0 01-March-2006 57
Step 7. Install lamp by pressing firmly into socket. Ensure lamp is fully seated in socket with base
of lamp against socket base.
Step 8. Install lamp into lamp socket taking care not to touch lamp glass.
Step 9. Close and re-latch back of luminaire.
Step 10. Disengage service tilt lock to allow luminaire head to move freely.
Step 11. If required, reset lamp hour counter as follows. (Refer to “Menu System Functions” chapter
on page 46 for more information.)
a. Power up luminaire.
b. At Menu Display, press [Menu].
c. Press [Up] / [Down] arrows until CFG (Configuration) appears. Press [Enter].
d. Press [Up] / [Down] arrows until LAMP appears. Press [Enter].
e. Press [Up] / [Down] arrows to access RHrs. Press [Enter] to reset lamp hour and strike
counters.
To Next Page
Loading...
